Errdisable Detect Cause - Cisco Catalyst 3650 series Command Reference Manual

errdisable detect cause

errdisable detect cause
To enable error-disable detection for a specific cause or for all causes, use the errdisable detect cause
command in global configuration mode. To disable the error-disable detection feature, use the no form of this
command.
errdisable detect cause {all| arp-inspection| bpduguard shutdown vlan| dhcp-rate-limit| dtp-flap|
gbic-invalid| inline-power| l2ptguard| link-flap| loopback| pagp-flap| pppoe-ia-rate-limit |
security-violation shutdown vlan| sfp-config-mismatch}
no errdisable detect cause {all| arp-inspection| bpduguard shutdown vlan| dhcp-rate-limit| dtp-flap|
gbic-invalid| inline-power| l2ptguard| link-flap| loopback| pagp-flap| pppoe-ia-rate-limit |
security-violation shutdown vlan| sfp-config-mismatch}
Syntax Description
all
arp-inspection
bpduguard shutdown vlan
dhcp-rate-limit
dtp-flap
gbic-invalid
inline-power
l2ptguard
link-flap
loopback
pagp-flap
pppoe-ia-rate-limit
security-violation shutdown
vlan
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
36
Enables error detection for all error-disabled causes.
Enables error detection for dynamic Address Resolution Protocol (ARP)
inspection.
Enables per-VLAN error-disable for BPDU guard.
Enables error detection for DHCP snooping.
Enables error detection for the Dynamic Trunking Protocol (DTP)
flapping.
Enables error detection for an invalid Gigabit Interface Converter (GBIC)
module.
This error refers to an invalid small form-factor pluggable (SFP)
Note
module.
Enables error detection for the Power over Ethernet (PoE) error-disabled
cause.
This keyword is supported only on switches with PoE
Note
ports.
Enables error detection for a Layer 2 protocol-tunnel error-disabled cause.
Enables error detection for link-state flapping.
Enables error detection for detected loopbacks.
Enables error detection for the Port Aggregation Protocol (PAgP) flap
error-disabled cause.
Enables error detection for the PPPoE Intermediate Agent rate-limit
error-disabled cause.
Enables voice aware 802.1x security.