Debug Sampler - Cisco Catalyst 3650 series Command Reference Manual

debug sampler

To enable debugging output for Flexible NetFlow samplers, use the debug sampler command in privileged
EXEC mode. To disable debugging output, use the no form of this command.
debug sampler [detailed| error| [name] sampler-name [detailed| error| sampling samples]]
no debug sampler [detailed| error| [name] sampler-name [detailed| error| sampling]]
Syntax Description
detailed
error
name
sampler-name
sampling samples
Command Modes
Privileged EXEC
Command History
Release
Cisco IOS XE 3.3SE
Examples The following sample output shows that the debug process has obtained the ID for the sampler named
SAMPLER-1:
Device# debug sampler detailed
*May 28 04:14:30.883: Sampler: Sampler(SAMPLER-1: flow monitor FLOW-MONITOR-1 (ip,Et1/0,O)
get ID succeeded:1
*May 28 04:14:30.971: Sampler: Sampler(SAMPLER-1: flow monitor FLOW-MONITOR-1 (ip,Et0/0,I)
get ID succeeded:1
(Optional) Enables detailed debugging for sampler elements.
(Optional) Enables debugging for sampler errors.
(Optional) Specifies the name of a sampler.
(Optional) Name of a sampler that was previously configured.
(Optional) Enables debugging for sampling and specifies the number of
samples to debug.
Modification
This command was introduced.
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
debug sampler
423