Show Eee - Cisco Catalyst 3650 series Command Reference Manual

show eee

To display Energy Efficient Ethernet (EEE) information for an interface, use the show eee command in EXEC
mode.
show eee{capabilities| status}interfaceinterface-id
Syntax Description
capabilities
status
interface interface-id
Command Default
None
Command Modes
User EXEC
Privileged EXEC
Command History
Release
Cisco IOS XE 3.3SE
Usage Guidelines
You can enable EEE on devices that support low power idle (LPI) mode. Such devices can save power by
entering LPI mode during periods of low power utilization. In LPI mode, systems on both ends of the link
can save power by shutting down certain services. EEE provides the protocol needed to transition into and
out of LPI mode in a way that is transparent to upper layer protocols and applications.
To check if an interface is EEE capable, use the show eee capabilities command. You can enable EEE on an
interface that is EEE capable by using the power efficient-ethernet auto interface configuration command.
To view the EEE status, LPI status, and wake error count information for an interface, use the show eee status
command.
Examples This is an example of output from the show eee capabilities command on an interface where EEE is enabled:
Device# show eee capabilities interface gigabitethernet1/0/1
Gi1/0/1
EEE(efficient-ethernet):
Link Partner :
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
Displays EEE capabilities for the specified interface.
Displays EEE status information for the specified
interface.
Specifies the interface for which to display EEE
capabilities or status information.
yes (100-Tx and 1000T auto)
yes (100-Tx and 1000T auto)
show eee
Modification
This command was introduced.
67