Rep Admin Vlan - Cisco Catalyst 3650 series Command Reference Manual

rep admin vlan

rep admin vlan
To configure a Resilient Ethernet Protocol (REP) administrative VLAN for REP to transmit hardware flood
layer (HFL) messages, use the rep admin vlan command in global configuration mode. To return to the
default configuration with VLAN 1 as the administrative VLAN, use the no form of this command.
rep admin vlan vlan-id
no rep admin vlan
Syntax Description
vlan-id
Command Default
The default value of the administrative VLAN is VLAN 1.
Command Modes
Global configuration (config)
Command History
Release
Cisco IOS XE Denali 16.2.2
Usage Guidelines
The range of the REP administrative VLAN is from 2 to 4094.
If you do not configure an administrative VLAN, the default VLAN is VLAN 1. The default VLAN 1 is
always configured. There can be only one administrative VLAN on a router and on a segment.
You can verify your settings by entering the show interfaces rep detail privileged EXEC command.
Examples The following example shows how to configure VLAN 100 as the REP administrative VLAN:
Device(config)#
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
326
The 48-bit static MAC address.
rep admin vlan 100
Modification
This command was introduced