Rep Lsl-Age-Timer - Cisco Catalyst 3650 series Command Reference Manual

rep lsl-age-timer

To configure the REP link status layer (LSL) age-out timer value, use the rep lsl-age-timer command in
interface configuration mode. To restore the default age-out timer value, use the no form of this command.
rep lsl-age-timer milliseconds
no rep lsl-age-timer milliseconds
Syntax Description
milliseconds
Command Default
The default LSL age-out timer value is 5 ms.
Command Modes
Interface configuration (config-if)
Command History
Release
Cisco IOS XE Denali 16.2.2
Usage Guidelines
The rep lsl-age-timer command is used to configure the REP LSL age-out timer value. While configuring
REP configurable timers, we recommend that you configure the REP LSL number of retries first and then
configure the REP LSL age-out timer value.
Examples The following example shows how to configure REP LSL age-out timer value.
Device(config)#
Device(config-if)#
Device(config-if)#
REP LSL age-out timer value in milliseconds (ms). The range is from 120 ms
to 10000 ms in multiples of 40 ms.
interface TenGigabitEthernet 4/1
rep segment 1 edge primary
rep lsl-age-timer 2000
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
rep lsl-age-timer
Modification
This command was introduced
329