Command Reference, Cisco Ios Xe Everest 16.5.1A (Catalyst 3650 Switches - Cisco Catalyst 3650 series Command Reference Manual

show env
1B PWR-C1-715WAC
Device# show env power all
SW PID
-- ------------------
1A PWR-C2-250WAC
1B Not Present
This is an example of output from the show env stack command on the active switch:
Device> show env stack
SWITCH: 1
Switch 1 FAN 1 is OK
Switch 1 FAN 2 is OK
Switch 1 FAN 3 is OK
FAN PS-1 is NOT PRESENT
FAN PS-2 is OK
Switch 1: SYSTEM TEMPERATURE is OK
Temperature Value: 28 Degree Celsius
Temperature State: GREEN
Yellow Threshold : 41 Degree Celsius
Red Threshold
This example shows how to display the temperature value, state, and the threshold values on a standalone
switch. The table describes the temperature states in the command output.
Device> show env temperature status
Temperature Value: 33 Degree Celsius
Temperature State: GREEN
Yellow Threshold : 65 Degree Celsius
Red Threshold
Table 7: States in the show env temperature status Command Output
State
Green
Yellow
Red

Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)

72
LIT150119Z1 OK
Serial# Status
---------- ---------------
LIT16372A1M OK
: 56 Degree Celsius
: 75 Degree Celsius
Good Good
Sys Pwr PoE Pwr
------- -------
Good Good
Description
The switch temperature is in the normal operating
range.
The temperature is in the warning range. You should
check the external temperature around the switch.
The temperature is in the critical range. The switch
might not run properly if the temperature is in this
range.
715
Watts
-----
250