Ip Nhrp Map; Command Reference, Cisco Ios Xe Everest 16.5.1A (Catalyst 3650 Switches - Cisco Catalyst 3650 series Command Reference Manual

ip nhrp map

To statically configure the IP-to-nonbroadcast multiaccess (NBMA) address mapping of IP destinations
connected to an NBMA network, use the ip nhrp map command in interface configuration mode. To remove
the static entry from Next Hop Resolution Protocol (NHRP) cache, use the no form of this command.
ip nhrp map ip-address {ip-nbma-address | destination-mask [ip-nbma-address | ipv6-nbma-address] |
ipv6-nbma-address}
no ip nhrp map ip-address {ip-nbma-address | destination-mask [ip-nbma-address | ipv6-nbma-address] |
ipv6-nbma-address}
Syntax Description
ip-address
ip-nbma-address
destination-mask
ipv6-nbma-address
Command Default
No static IP-to-NBMA cache entries exist.
Command Modes
Interface configuration(config-if)
Command History
Release
Cisco IOS XE Denali 16.3.1
Usage Guidelines
In Cisco IOS XE Denali 16.3.1, NHRP supports only hub-to-spoke communication; spoke-to-spoke
communication is not supported.
IP address of the destinations reachable through the
NBMA network. This address is mapped to the
NBMA address.
NBMA address that is directly reachable through the
NBMA network. The address format varies depending
on the medium; for example, ATM has a Network
Service Access Point (NSAP) address, Ethernet has
a MAC address, and Switched Multimegabit Data
Service (SMDS) has an E.164 address. This address
is mapped to the IP address.
Destination address mask.
IPv6 NBMA address.
Note
Modification
This command was introduced.

Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)

ip nhrp map
This argument is not supported in Cisco IOS
XE Denali 16.3.1.
175