Interface Range - Cisco Catalyst 3650 series Command Reference Manual

interface range

interface range
To configure an interface range, use the interface range command.
interface range {Gigabit Ethernet interface-number | Loopback interface-number | Port Channel
interface-number | TenGigabit Ethernet interface-number Tunnel interface-number Vlan
interface-number Macro WORD}
Syntax Description
GigabitEthernet interface-number
Loopback interface-number
Port-Channel interface-number
TenGigabit Ethernet interface-number
Tunnel interface-number
VLAN interface-number
Macro WORD
Command Default
None
Command Modes
Global configuration
Command History
Release
Cisco IOS XE 3.3SE
Examples This example shows how you can configure interface range:
Device(config)# interface range vlan 1
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
44
Configures the Gigabit Ethernet IEEE 802.3z interface. Values
range from 1 to 9.
Configures the loopback interface. Values range from 0 to
2147483647.
Configures 10-Gigabit Ethernet channel of interfaces. Values
range from 1 to 128.
Configures 10-Gigabit Ethernet interfaces. Values range from 0
to 9.
Configures the tunnel interface. Values range from 0 to
2147483647.
Configures the switch VLAN interfaces. Values range from 1 to
4095.
Configures the keywords to interfaces. Support up to 32 characters.
Modification
This command was introduced.