Erspan-Id - Cisco Catalyst 3650 series Command Reference Manual
Cisco ios xe everest 16.5.1a
Hide thumbs
Also See for Catalyst 3650 series:
- Hardware installation manual (126 pages) ,
- Configuration manual (94 pages) ,
- Manual (94 pages)
Table of Contents
Advertisement
erspan-id
erspan-id
To configure the ID used by the destination session to identify the Encapsulated Remote Switched Port
Analyzer (ERSPAN) traffic, use the erspan-id command in ERSPAN monitor destination session configuration
mode. To remove the configuration, use the no form of this command.
erspan-id erspan-ID
no erspan-id erspan-ID
Syntax Description
erspan-id
Command Default
ERSPAN IDs for destination sessions are not configured.
Command Modes
ERSPAN monitor destination session configuration mode (config-mon-erspan-src-dst)
Command History
Release
Cisco IOS XE Denali 16.3.1
Examples
The following example shows how to configure an ERSPAN ID for a destination session:
Switch(config)# monitor session 2 type erspan-source
Switch(config-mon-erspan-src)# destination
Switch(config-mon-erspan-src-dst)# erspan-id 3
Related Commands
Command
destination
monitor session type erspan-source
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
484
ERSPAN ID used by the destination session. Valid values are from 1 to 1023.
Modification
This command was introduced.
Description
Configures an ERSPAN destination session and
specifies destination properties.
Configures a local ERSPAN source session.
Advertisement
Table of Contents
