Ip Igmp Profile - Cisco Catalyst 3650 series Command Reference Manual

ip igmp profile

ip igmp profile
To create an Internet Group Management Protocol (IGMP) profile and enter IGMP profile configuration
mode, use the ip igmp profile global configuration command on the device stack or on a standalone device.
From this mode, you can specify the configuration of the IGMP profile to be used for filtering IGMP
membership reports from a switch port. To delete the IGMP profile, use the no form of this command.
ip igmp profile profile number
no ip igmp profile profile number
Syntax Description
profile number
Command Default
No IGMP profiles are defined. When configured, the default action for matching an IGMP profile is to deny
matching addresses.
Command Modes
Global configuration
Command History
Release
Cisco IOS XE 3.3SE
Usage Guidelines
When you are in IGMP profile configuration mode, you can create the profile by using these commands:
• deny—Specifies that matching addresses are denied; this is the default condition.
• exit—Exits from igmp-profile configuration mode.
• no—Negates a command or resets to its defaults.
• permit—Specifies that matching addresses are permitted.
• range—Specifies a range of IP addresses for the profile. This can be a single IP address or a range with
You can apply an IGMP profile to one or more Layer 2 interfaces, but each interface can have only one profile
applied to it.
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
220
a start and an end address.
When entering a range, enter the low IP multicast address, a space, and the high IP multicast address.
The IGMP profile number being configured. The range is from 1 to
4294967295.
Modification
This command was introduced.