Snmp-Server Enable Traps Call-Home - Cisco Catalyst 3650 series Command Reference Manual

snmp-server enable traps call-home

To enable SNMP CISCO-CALLHOME-MIB traps, use the snmp-server enable traps call-home command
in global configuration mode. Use the no form of this command to return to the default setting.
snmp-server enable traps call-home [message-send-fail | server-fail]
no snmp-server enable traps call-home [message-send-fail | server-fail]
Syntax Description
message-send-fail
server-fail
Command Default
The sending of SNMP CISCO-CALLHOME-MIB traps is disabled.
Command Modes
Global configuration
Command History
Release
Cisco IOS XE 3.3SECisco IOS XE 3.3SE
Usage Guidelines
Specify the host (NMS) that receives the traps by using the snmp-server host global configuration command.
If no trap types are specified, all trap types are sent.
Informs are not supported in SNMPv1.
Note
To enable more than one type of trap, you must enter a separate snmp-server enable traps command for
each trap type.
Examples This example shows how to generate SNMP message-send-fail traps:
Device(config)# snmp-server enable traps call-home message-send-fail
(Optional) Enables SNMP message-send-fail traps.
(Optional) Enables SNMP server-fail traps.
Modification
This command was introduced.
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
snmp-server enable traps call-home
537