Show Glbp - Cisco Catalyst 3650 series Command Reference Manual

show glbp

To display Gateway Load Balancing Protocol (GLBP) information, use the show glbp command in privileged
EXEC mode.
capability [interface-type interface-number]interface-type interface-number [ group-number ] [ state ] [brief]
Syntax Description
capability
interface-type interface-number
group-number
state
brief
Command Modes
Privileged EXEC (#)
Command History
Release
Cisco IOS XE Release 2.1
Usage Guidelines
Use the show glbp command to display information about GLBP groups on a device. The brief keyword
displays a single line of information about each virtual gateway or virtual forwarder. The capability keyword
displays all GLBP-capable interfaces.
Examples The following is sample output from the show glbp command that displays GLBP group 10:
Device# show glbp GigabitEthernet 1/0/1 10
GigabitEthernet1/0/1 - Group 10
State is Active
Virtual IP address is 10.21.8.10
Hello time 3 sec, hold time 10 sec
Redirect time 600 sec, forwarder time-out 14400 sec
Preemption disabled
Active is local
Standby is unknown
Priority 100 (default)
1 state change, last state change 00:04:52
Next hello sent in 0.608 secs
(Optional) Displays the GLBP capability interfaces.
(Optional) Interface type and number for which output
is displayed.
(Optional) GLBP group number in the range from 0
to 1023.
(Optional) State of the GLBP device, one of the
following: active, disabled, init, listen, and standby.
(Optional) Summarizes each virtual gateway or virtual
forwarder with a single line of output.
Modification
This command was introduced..
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
show glbp
187