Ip Ttl (Erspan) - Cisco Catalyst 3650 series Command Reference Manual
Cisco ios xe everest 16.5.1a
Hide thumbs
Also See for Catalyst 3650 series:
- Hardware installation manual (126 pages) ,
- Configuration manual (94 pages) ,
- Manual (94 pages)
Table of Contents
Advertisement
ip ttl (ERSPAN)
To configure Time to Live (TTL) values for packets in the Encapsulated Remote Switched Port Analyzer
(ERSPAN) traffic, use the ip ttl command in ERSPAN monitor destination session configuration mode. To
remove the TTL values, use the no form of this command,
ip ttl ttl-value
no ip ttl ttl-value
Syntax Description
ttl-value
Command Default
TTL value is set as 255.
Command Modes
ERSPAN monitor destination session configuration mode (config-mon-erspan-src-dst)
Command History
Release
Cisco IOS XE Denali 16.3.1
Examples
The following example shows how to configure TTL value for ERSPAN traffic:
Switch(config)# monitor session 2 type erspan-source
Switch(config-mon-erspan-src)# destination
Switch(config-mon-erspan-src-dst)# ip ttl 32
Related Commands
Command
destination
monitor session type erspan-source
TTL value. Valid values are from 2 to 255.
Modification
This command was introduced.
Description
Configures an ERSPAN destination session and
specifies destination properties.
Configures a local ERSPAN source session.
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
ip ttl (ERSPAN)
487
Advertisement
Table of Contents
