Dot1X Test Timeout - Cisco Catalyst 3650 series Command Reference Manual

dot1x test timeout

To configure the timeout used to wait for EAPOL response from a port being queried for IEEE 802.1x readiness,
use the dot1x test timeout command in global configuration mode on the switch stack or on a standalone
switch.
dot1x test timeout timeout
Syntax Description
timeout
Command Default
The default setting is 10 seconds.
Command Modes
Global configuration
Command History
Release
Cisco IOS XE 3.3SECisco IOS XE 3.3SE
Usage Guidelines
Use this command to configure the timeout used to wait for EAPOL response.
There is not a no form of this command.
Examples This example shows how to configure the switch to wait 27 seconds for an EAPOL response:
Device# dot1x test timeout 27
You can verify the timeout configuration status by entering the show run privileged EXEC command.
Related Commands
Command
dot1x test eapol-capable [interface
interface-id]
Time in seconds to wait for an EAPOL response. The
range is from 1 to 65535 seconds.
Description
Checks for IEEE 802.1x readiness on devices connected to all
or to specified IEEE 802.1x-capable ports.
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
dot1x test timeout
Modification
This command was introduced.
753