Show Platform Software Process Slot Switch - Cisco Catalyst 3650 series Command Reference Manual

show platform software process slot switch

To display platform software process switch information, use the show platform software process slot switch
command in privileged EXEC mode.
show platform software process slot switch {switch-number | active | standby} {0 | F0 | R0} monitor
[cycles no-of-times [interval delay [lines number]]]
Syntax Description
switch-number
active
standby
0
F0
R0
monitor
cycles no-of-tmes
interval delay
lines number
Command Modes
Privileged EXEC (#)
Command History
Release
Cisco IOS XE Denali 16.1.1
Usage Guidelines
The output of the show platform software process slot switch and show processes cpu platform monitor
location commands display the output of the Linux top command. The output of these commands display
Switch number.
Specifies the active instance.
Specifies the standby instance.
Specifies the shared port adapter (SPA) interface
processor slot 0.
Specifies the Embedded Service Processor (ESP)
slot 0.
Specifies the Route Processor (RP) slot 0.
Monitors the running processes.
(Optional) Sets the number of times to run monitor
command. Valid values are from 1 to 4294967295.
The default is 5.
(Optional) Sets a delay after each . Valid values
are from 0 to 300. The default is 3.
(Optional) Sets the number of lines of output
displayed. Valid values are from 0 to 512. The
default is 0.
Modification
This command was introduced.
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
show platform software process slot switch
105