Glbp Load-Balancing - Cisco Catalyst 3650 series Command Reference Manual

glbp load-balancing

glbp load-balancing
To specify the load-balancing method used by the active virtual gateway (AVG) of the Gateway Load Balancing
Protocol (GLBP), use the glbp load-balancing command in interface configuration mode. To disable load
balancing, use the no form of this command.
glbp group load-balancing [host-dependent| round-robin| weighted]
no glbp group load-balancing
Syntax Description
group
host-dependent
round-robin
weighted
Command Default
The round-robin method is the default.
Command Modes
Interface configuration (config-if)
Command History
Release
Cisco IOS XE Release 2.1
Usage Guidelines
Use the host-dependent method of GLBP load balancing when you need each host to always use the same
device. Use the weighted method of GLBP load balancing when you need unequal load balancing because
devices in the GLBP group have different forwarding capacities.
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
154
GLBP group number in the range from 0 to 1023.
(Optional) Specifies a load balancing method based
on the MAC address of a host where the same
forwarder is always used for a particular host while
the number of GLBP group members remains
unchanged.
(Optional) Specifies a load balancing method where
each virtual forwarder in turn is included in address
resolution replies for the virtual IP address. This
method is the default.
(Optional) Specifies a load balancing method that is
dependent on the weighting value advertised by the
gateway.
Modification
This command was introduced..