Rep Segment - Cisco Catalyst 3650 series Command Reference Manual

rep segment

To enable REP on the interface and to assign a segment ID to the interface, use the rep segment command
in interface configuration mode. To disable REP on the interface, use the no form of this command.
rep segment segment-id [edge [no-neighbor] [primary]] [preferred]
no rep segment
Syntax Description
segment-id
edge
no-neighbor
primary
preferred
Command Default
REP is disabled on the interface.
Command Modes
Interface configuration (config-if)
Command History
Release
Cisco IOS XE Denali 16.2.2
Usage Guidelines
REP ports must be a Layer 2 IEEE 802.1Q port or 802.1AD port. You must configure two edge ports on each
REP segment, a primary edge port and a port to act as a secondary edge port.
If REP is enabled on two ports on a router, both ports must be either regular segment ports or edge ports. REP
ports follow these rules:
• If only one port on a router is configured in a segment, the port should be an edge port.
• If two ports on a router belong to the same segment, both ports must be regular segment ports.
Segment for which REP is enabled. Assign a segment ID to the interface. The range
is from 1 to 1024.
(Optional) Configures the port as an edge port. Each segment has only two edge ports.
(Optional) Specifies the segment edge as one with no external REP neighbor.
(Optional) Specifies that the port is the primary edge port where you can configure
VLAN load balancing. A segment has only one primary edge port.
(Optional) Specifies that the port is the preferred alternate port or the preferred port
for VLAN load balancing.
Configuring a port as preferred does not guarantee that it becomes the
Note
alternate port; it merely gives it a slight edge among equal contenders. The
alternate port is usually a previously failed port.
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
rep segment
Modification
This command was introduced
333