Bfd Template - Cisco Catalyst 3650 series Command Reference Manual

bfd template

To bind a single hop Bidirectional Forwarding Detection (BFD) template to an interface, use the bfd template
command in interface configuration mode. To unbind single-hop BFD template from an interface, use the no
form of this command
bfd template template-name
no bfd template template-name
Command Default
A BFD template is not bound to an interface.
Command Modes
Interface configuration (config-if)
Command History
Release
Cisco IOS XE Denali 16.3.1
Usage Guidelines
Even if you have not created the template by using the bfd-template command, you can configure the name
of the template under an interface, but the template is considered invalid until you define the template. You
do not have to reconfigure the template name again. It becomes valid automatically.
Device> enable
Examples
Device# configuration terminal
Device(config)# interface Gigabitethernet 1/3/0
Device(config-if)# bfd template template1
Modification
This command was introduced.
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
bfd template
693