Ip Multicast-Routing - Cisco Catalyst 3650 series Command Reference Manual
Cisco ios xe everest 16.5.1a
Hide thumbs
Also See for Catalyst 3650 series:
- Hardware installation manual (126 pages) ,
- Configuration manual (94 pages) ,
- Manual (94 pages)
Table of Contents
Advertisement
ip multicast-routing
ip multicast-routing
To enable IP multicast routing, use the ip multicast-routing command in global configuration mode. To
disable IP multicast routing, use the no form of this command.
ip multicast-routing [vrf vrf-name]
no ip multicast-routing [vrf vrf-name]
Syntax Description
vrf vrf-name
Command Default
IP multicast routing is disabled.
Command Modes
Global configuration (config).
Command History
Release
Cisco IOS XE Denali 16.3.2
Usage Guidelines
When IP multicast routing is disabled, the Cisco IOS software does not forward any multicast packets.
Note
For IP multicast, after enabling IP multicast routing, PIM must be configured on all interfaces. Disabling
IP multicast routing does not remove PIM; PIM still must be explicitly removed from the interface
configurations.
Examples
The following example shows how to enable IP multicast routing:
Switch(config)# ip multicast-routing
The following example shows how to enable IP multicast routing on a specific VRF:
Switch(config)#
ip multicast-routing vrf vrf1
The following example shows how to disable IP multicast routing:
Switch(config)#
no ip multicast-routing
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
386
(Optional) Enables IP multicast routing for the
Multicast VPN routing and forwarding (MVRF)
instance specified for the vrf-name argument.
Modification
This command was introduced.
Advertisement
Table of Contents
