Ip Nhrp Nhs; Command Reference, Cisco Ios Xe Everest 16.5.1A (Catalyst 3650 Switches - Cisco Catalyst 3650 series Command Reference Manual

ip nhrp nhs

ip nhrp nhs
To specify the address of one or more Next Hop Resolution Protocol (NHRP) servers, use the ip nhrp nhs
command in interface configuration mode. To remove the address, use the no form of this command.
ip nhrp nhs {nhs-address [nbma {nbma-address | FQDN-string}] [multicast] [priority value] [cluster
value] | cluster value max-connections value | dynamic nbma {nbma-address | FQDN-string} [multicast]
[priority value] [cluster value] | fallback seconds}
no ip nhrp nhs {nhs-address [nbma {nbma-address | FQDN-string}] [multicast] [priority value] [cluster
value] | cluster value max-connections value | dynamic nbma {nbma-address | FQDN-string} [multicast]
[priority value] [cluster value] | fallback seconds}
Syntax Description
nhs-address
nbma
nbma-address
FQDN-string
multicast
priority value
cluster value
max-connections value
dynamic
fallback seconds

Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)

180
Address of the next-hop server being specified.
(Optional) Specifies the nonbroadcast multiple access
(NBMA) address or FQDN.
NBMA address.
Next hop server (NHS) fully qualified domain name
(FQDN) string.
(Optional) Specifies the use of NBMA mapping for
broadcasts and multicasts.
(Optional) Assigns a priority to hubs to control the
order in which spokes select hubs to establish tunnels.
The range is from 0 to 255; 0 is the highest and 255
is the lowest priority.
(Optional) Specifies NHS groups. The range is from
0 to 10.
Specifies the number of NHS elements from each
NHS group that needs to be active. The range is from
0 to 255.
Configures the spoke to learn the NHS protocol
address dynamically.
Specifies the duration, in seconds, for which the spoke
must wait before falling back to an NHS of higher
priority upon recovery.