Chapter 4: Performing Predelivery Checks; Checking Drive Belts - MacDon R85 Assembly Instructions Manual

4 Performing Predelivery Checks
DANGER
To avoid bodily injury or death from unexpected startup of the machine, always stop the engine and
remove the key from the ignition before leaving the operator's seat for any reason.
IMPORTANT:
To avoid machine damage, check that no shipping dunnage has fallen down between auger and pans.
1. Perform final checks and adjustments as listed on the yellow sheet attached to back of this instruction, to
ensure the machine is field-ready. Refer to the referenced pages as indicated on the checklist for detailed
instructions.
2. The completed checklist should be retained either by the Operator or the Dealer.

4.1 Checking Drive Belts

Drive belt tensions have been properly set at the factory and should not require further adjustment. Check as
follows:
1. Open driveshield. For instructions, refer to
Driveshields, page 75.
214367
3.15.1
Figure 4.1: Driveshield
81
Revision A