Command Line Console Management - Optical Systems Design OSD2700SFP SERIES Operator's Manual

OPTICAL SYSTEMS DESIGN

7 COMMAND LINE CONSOLE MANAGEMENT

The switch provides a command line console interface for configuration purposes. The switch can be
configured either locally through its RS-232 port or remotely via a Telnet session. For the later, you
must specify an IP address for the switch first.
This chapter describes how to configure the switch using its console by Command Line.
7.1 ADMINISTRATION CONSOLE
Connect the DB9 straight cable to the RS-232 serial port of the device to the RS-232 serial port of the
terminal or computer running the terminal emulation application.
Direct access to the administration console is achieved by directly connecting a terminal or a PC
equipped with a terminal-emulation program (such as HyperTerminal) to the switch console port.
When using the management method, configure the terminal-emulation program to use the following
parameters (you can change these settings after login):
[Default parameters]
115,200bps
8 data bits
No parity
1 stop bit
DOC ID: 10112704
PAGE 105
OSD2700SFP OPERATOR MANUAL