Optical Systems Design OSD2700SFP SERIES Operator's Manual page 207

ip igmp query-max-response-time RESPONSETIME
no ip igmp query-max-response-time
RESPONSETIME <1-240> Maximum response time (in seconds) advertised in IGMP queries.
Default: 10 seconds.
4. Example:
The following example configures a maximum response time of 8 seconds on vlan1.1:
switch_a(config)#interface vlan1.1
switch_a(config-if)#ip igmp query-max-response-time 8
switch_a(config-if)#
IGMP passive snooping:
Static mc router port:
1. Command Mode: Interface mode
Logon to Configure Mode (Configure Terminal Mode).
Then logon to Interface mode.
vlan1.1 means vlan 1.
The switch_a(config-if)# prompt will show on the screen.
switch_a(config)#interface vlan1.1
switch_a(config-if)#
2. Usage:
Use ip igmp snooping mrouter interface command to statically configure the specified VLAN
constituent interface as a multicast router interface for IGMP Snooping in that VLAN.
Use the no ip igmp snooping mrouter interface command to remove the static configuration of the
interface as a multicast router interface.
3. Command Syntax:
(no) ip igmp snooping mrouter interface IFNAME
IFNAME Specify the name of the interface
4. Example:
The following example shows interface fe1 (port 1) statically configured to be a multicast router
interface on vlan1.1:
switch_a(config)#interface vlan1.1
switch_a(config-if)#ip igmp snooping mrouter interface fe1
switch_a(config-if)#
IGMP passive snooping:
Report suppression:
1. Command Mode: Interface mode
Logon to Configure Mode (Configure Terminal Mode).
Then logon to Interface mode.
vlan1.1 means vlan 1.
The switch_a(config-if)# prompt will show on the screen.
switch_a(config)#interface vlan1.1
switch_a(config-if)#
2. Usage:
Use ip igmp snooping report-suppression command to enable report suppression for IGMP versions
1 and 2.
PAGE 207
OSD2700SFP OPERATOR MANUAL
OPTICAL SYSTEMS DESIGN
DOC ID: 10112704