Optical Systems Design OSD2700SFP SERIES Operator's Manual page 213

Use this command to enable/disable GMRP globally on a particular bridge. This command does not
enable/disable GMRP in all ports of the bridge. After enabling GMRP globally, use the set port gmrp
command to enable GMRP on individual ports of the bridge. GMRP cannot be enabled if IGMP
Snooping is enabled, or if GMRP has already been configured for a particular VLAN.
3. Command Syntax:
set gmrp enable ∣ d isable bridge BRIDGE_NAME
enable Enable GMRP on Layer-2 switch.
disable Disable GMRP on Layer-2 switch
BRIDGE_NAME The text string to use for the name of the bridge.
4. Example:
The following example enables GMRP on a Layer-2 switch for bridge 1:
switch_a(config)#set gmrp enable bridge 1
switch_a(config)#
Set Port GMRP:
1. Command Mode: Configure mode
Logon to Configure Mode (Configure Terminal Mode).
The switch_a(config)# prompt will show on the screen.
switch_a(config)#
2. Usage:
Use this command to enable/disable GMRP on a particular port in all VLANs or all ports in a bridge.
GMRP on a port cannot be enabled for all VLANs if GMRP has already been configured for a
particular VLAN for the port.
3. Command Syntax:
∣
set port gmrp enable d isable all
enable Enable GMRP on Layer-2 switch port
disable Disable GMRP on Layer-2 switch port
all All ports added to recently configured bridge
IF_NAME Specify the name of the interface.
4. Example:
The following example enables GMRP on interface fe1 (port 1):
switch_a(config)#set port gmrp enable fe1
switch_a(config)#
The following example enables GMRP on all ports:
switch_a(config)#set port gmrp enable all
switch_a(config)#
GMRP Registration:
1. Command Mode: Configure mode
Logon to Configure Mode (Configure Terminal Mode).
The switch_a(config)# prompt will show on the screen.
switch_a(config)#
2. Usage:
PAGE 213
OSD2700SFP OPERATOR MANUAL
OPTICAL SYSTEMS DESIGN
∣
I F_NAME
DOC ID: 10112704