Optical Systems Design OSD2700SFP SERIES Operator's Manual page 173

802.1Q PORT SETTING
Switchport mode access:
1. Command Mode: Interface mode
Logon to Configure Mode (Configure Terminal Mode).
Then logon to Interface mode.
fe1 means port 1.
The switch_a(config-if)# prompt will show on the screen.
switch_a(config)#interface fe1
switch_a(config-if)#
2. Usage:
Use switchport mode access command to set the switching characteristics of the Layer-2 interface to
access mode, and classify untagged frames only.
Use the no switchport access command to reset the mode of the Layer-2 interface to access (default).
3. Command Syntax:
switchport mode access
no switchport access
4. Example:
The following example sets the switchport mode access of the interface fe1 (port 1):
switch_a(config)#interface fe1
switch_a(config-if)#switchport mode access
switch_a(config-if)#
Switchport mode hybrid:
1. Command Mode: Interface mode
Logon to Configure Mode (Configure Terminal Mode).
Then logon to Interface mode.
fe1 means port 1.
The switch_a(config-if)# prompt will show on the screen.
switch_a(config)#interface fe1
switch_a(config-if)#
2. Usage:
Use switchport mode hybrid command to set the switching characteristics of the Layer-2 interface as
hybrid, and classify both tagged and untagged frames.
Use the no switchport hybrid command to reset the mode of the Layer-2 interface to access (default).
3. Command Syntax:
switchport mode hybrid
switchport mode hybrid acceptable-frame-type all/vlan-tagged
no switchport hybrid
all Set all frames can be received.
vlan-tagged Set vlan-tagged frames can only be received.
4. Example:
The following example sets the switchport mode hybrid of the interface fe1 (port 1) and all frames to
be received on interface fe1 (port 1):
switch_a(config)#interface fe1
switch_a(config-if)#switchport mode hybrid acceptable-frame-type all
switch_a(config-if)#
PAGE 173
OSD2700SFP OPERATOR MANUAL
OPTICAL SYSTEMS DESIGN
DOC ID: 10112704