Optical Systems Design OSD2700SFP SERIES Operator's Manual page 176

Priority Level:
1. Command Mode: Interface mode
Logon to Configure Mode (Configure Terminal Mode).
Then logon to Interface mode.
fe1 means port 1.
The switch_a(config-if)# prompt will show on the screen.
switch_a(config)#interface fe1
switch_a(config-if)#
2. Usage:
Use this command to set user priority for port.
3. Command Syntax:
user-priority <0-7>
<0-7> User priority value.
4. Example:
The following example sets user priority (0) for the interface fe1 (port 1):
switch_a(config)#interface fe1
switch_a(config-if)#user-priority 0
switch_a(config-if)#
PORT BASED VLAN
Switchport portbase add/remove vlan:
1. Command Mode: Interface mode
Logon to Configure Mode (Configure Terminal Mode).
Then logon to Interface mode.
fe1 means port 1.
The switch_a(config-if)# prompt will show on the screen.
switch_a(config)#interface fe1
switch_a(config-if)#
2. Usage:
Use this command to set or remove the default VLAN for the interface.
3. Command Syntax:
switchport portbase add ｜ r emove vlan VLANID
VLANID The ID of the VLAN will be added to or removed from the Layer-2 interface.
4. Example:
The following example specifies to add the interface fe1 (port 1) to VLANID (2):
switch_a(config)#interface fe1
switch_a(config-if)#switchport portbase add vlan 2
switch_a(config-if)#
PAGE 176
OSD2700SFP OPERATOR MANUAL
OPTICAL SYSTEMS DESIGN
DOC ID: 10112704