Optical Systems Design OSD2700SFP SERIES Operator's Manual page 169

IFNAME Chain pass-through port number 2.
4. Example:
The following example enables the fe3 and fe4 as chain pass-through port 1 and chain pass-through
port 2:
switch_a(config)#chain pass-through fe3 fe4
switch_a(config)#
ADVANCED SETTING
Advanced Bridge Configuration:
Bridge bpdu-guard configuration:
1. Command Mode: Configure mode
Logon to Configure Mode (Configure Terminal Mode).
The switch_a(config)# prompt will show on the screen.
switch_a(config)#
2. Usage:
Use this command to enable the BPDU (Bridge Protocol Data Unit) Guard feature on a bridge.
Use the no parameter with this command to disable the BPDU Guard feature on a bridge.
When the BPDU Guard feature is set for a bridge, all portfast-enabled ports of the bridge that have
bpdu-guard set to default shut down the port on receiving a BPDU. In this case, the BPDU is not
processed.
3. Command Syntax:
bridge GROUP spanning-tree portfast bpdu-guard
no bridge GROUP spanning-tree portfast bpdu-guard
GROUP <1-1> Bridge-group ID used for bridging.
4. Example:
The following example enables the BPDU Guard feature on bridge GROUP (1):
switch_a(config)#bridge 1 spanning-tree portfast bpdu-guard
switch_a(config)#
Error disable timeout configuration:
1. Command Mode: Configure mode
Logon to Configure Mode (Configure Terminal Mode).
The switch_a(config)# prompt will show on the screen.
switch_a(config)#
2. Usage:
Use this command to enable the timeout mechanism for the port to be enabled back for a bridge.
Use the no parameter with this command to disable the timeout mechanism for the port to be enabled
back for a bridge.
3. Command Syntax:
bridge GROUP spanning-tree errdisable-timeout enable
no bridge GROUP spanning-tree errdisable-timeout enable
GROUP <1-1> Bridge-group ID used for bridging.
4. Example:
PAGE 169
OSD2700SFP OPERATOR MANUAL
OPTICAL SYSTEMS DESIGN
DOC ID: 10112704