Optical Systems Design OSD2700SFP SERIES Operator's Manual page 161

switch_a(config)#spanning-tree mst configuration
switch_a(config-mst)#
2. Usage:
Use this command to create an MST region and specify a name to it. MST bridges of a region form
different spanning trees for different VLANs. By default, each MST bridge starts with the region name
as its bridge address. This means each MST bridge is a region by itself, unless specifically added to
one.
3. Command Syntax:
bridge GROUP region REGION_NAME
no bridge GROUP region
GROUP <1-1> Specify the bridge-group ID.
REGION_NAME Specify the name of the region.
4. Example:
The following example creates an MST region and specifies a name (regionname) to it in bridge
GROUP (1):
Switch_a(config)#spanning-tree mst configuration
switch_a(config-mst)#bridge 1 region regionname
switch_a(config-mst)#
Revision Level:
1. Command Mode: MST Configuration mode
Logon to Configure Mode (Configure Terminal Mode).
Then logon to MST Configuration mode.
The switch_a(config-mst)# prompt will show on the screen.
switch_a(config)#spanning-tree mst configuration
switch_a(config-mst)#
2. Usage:
Use this command to specify the number for configuration information. The default value of revision
number is 0.
3. Command Syntax:
bridge GROUP revision REVISION_NUM
GROUP <1-1> Specify the bridge-group ID.
REVISION_NUM <0-255> Revision number.
4. Example:
The following example specifies a revision number (25) of MST configuration in bridge GROUP (1):
switch_a(config)#spanning-tree mst configuration
switch_a(config-mst)#bridge 1 revision 25
switch_a(config-mst)#
Max Hops:
1. Command Mode: Configure mode
Logon to Configure Mode (Configure Terminal Mode).
The switch_a(config)# prompt will show on the screen.
switch_a(config)#
PAGE 161
OSD2700SFP OPERATOR MANUAL
OPTICAL SYSTEMS DESIGN
DOC ID: 10112704