Table of Contents
Advertisement
Use this command to set the transmit interval. This is the interval between regular transmissions of
Link Layer Discovery Protocol (LLDP) advertisements.
3.
Command Syntax:
lldp txinterval <5-32768>
<5-32768> TxInterval 5-32768 seconds, default is 30 seconds.
4.
Example:
The following example sets Link Layer Discovery Protocol (LLDP) transmit interval to 60 seconds:
switch_a(config)#lldp txinterval 60
switch_a(config)#
Global TLV Setting:
1.
Command Mode: Configure mode
Logon to Configure Mode (Configure Terminal Mode).
The switch_a(config)# prompt will show on the screen.
switch_a(config)#
2.
Usage:
Use this command to configure Link Layer Discovery Protocol (LLDP) Type Length Value (TLV)
setting.
Use the no parameter with this command to disable Link Layer Discovery Protocol (LLDP) Type
Length Value (TLV) setting.
3.
Command Syntax:
(no) lldp tlv-global port-descr
phy
｜
protocol-identity
｜
port-descr Port Description TLV.
sys-name System Name TLV.
sys-descr System Description TLV.
sys-cap System Capabilities TLV.
mgmt-addrs Management Address TLV.
port-vlan-id Port VLAN ID TLV.
mac-phy MAC/PHY Configuration/Status TLV.
protocol-identity Protocol Identity TLV.
vlan-name VLAN Name TLV.
port-and-protocol Port And Protocol VLAN ID TLV.
power-mdi Power Via MDI TLV.
link-aggregation Link Aggregation TLV.
max-frame Maximum Frame Size TLV.
4.
Example:
The following example sets Link Layer Discovery Protocol (LLDP) Link Aggregation Type Length
Value (TLV):
switch_a(config)#lldp tlv-global link-aggregation
switch_a(config)#
PAGE 198
OSD2700SFP OPERATOR MANUAL
OPTICAL SYSTEMS DESIGN
｜
sys-name
｜
sys-descr
vlan-name
｜
port-and-protocol
｜
sys-cap
｜
mgmt-addrs
｜
｜
power-mdi
｜
link-aggregation
port-vlan-id
｜
m ac-
｜
m ax-frame
DOC ID: 10112704
Advertisement
Table of Contents
