Optical Systems Design OSD2700SFP SERIES Operator's Manual page 217

switch_a(config)#dhcp-server gateway 192.168.1.254
switch_a(config)#
DHCP Server DNS:
1. Command Mode: Configure mode
Logon to Configure Mode (Configure Terminal Mode).
The switch_a(config)# prompt will show on the screen.
switch_a(config)#
2. Usage:
Use this command to set the default DNS for the DHCP Server.
Use the no form of this command to remove this setting.
3. Command Syntax:
dhcp-server dns 1 ｜ 2 A.B.C.D
no dhcp-server dns 1 ｜ 2
A.B.C.D The default DNS for the DHCP Server.
4. Example:
The following example sets the default DNS for the DHCP Server:
switch_a(config)#dhcp-server dns 1 192.168.1.20
switch_a(config)#
DHCP Server Lease Time:
1. Command Mode: Configure mode
Logon to Configure Mode (Configure Terminal Mode).
The switch_a(config)# prompt will show on the screen.
switch_a(config)#
2. Usage:
Use this command to set the default lease time for the DHCP Server. Use the value 0 to reset this
setting.
3. Command Syntax:
dhcp-server lease-time <0-86400>
<0-86400> The default lease time for the DHCP Server (default: 86400).
4. Example:
The following example sets the default lease time for the DHCP Server:
switch_a(config)#dhcp-server lease-time 86400
switch_a(config)#
PAGE 217
OSD2700SFP OPERATOR MANUAL
OPTICAL SYSTEMS DESIGN
DOC ID: 10112704