Optical Systems Design OSD2700SFP SERIES Operator's Manual page 141

Broadcast:
1. Command Mode: Interface mode
Logon to Configure Mode (Configure Terminal Mode).
Then logon to Interface mode.
fe1 means port 1.
The switch_a(config-if)# prompt will show on the screen.
switch_a(config)#interface fe1
switch_a(config-if)#
2. Usage:
Use storm-control broadcast enable command to enable broadcast traffic.
Use no storm-control broadcast command to disable broadcast traffic.
3. Command Syntax:
storm-control broadcast enable
no storm-control broadcast
4. Example:
The following example shows setting storm-control broadcast enable to the interface fe1 (port 1):
switch_a(config)#interface fe1
switch_a(config-if)#storm-control broadcast enable
switch_a(config-if)#
Multicast:
1. Command Mode: Interface mode
Logon to Configure Mode (Configure Terminal Mode).
Then logon to Interface mode.
fe1 means port 1.
The switch_a(config-if)# prompt will show on the screen.
switch_a(config)#interface fe1
switch_a(config-if)#
2. Usage:
Use storm-control multicast enable command to enable multicast traffic.
Use no storm-control multicast command to disable multicast traffic.
3. Command Syntax:
storm-control multicast enable
no storm-control multicast
4. Example:
The following example shows setting storm-control multicast enable to the interface fe1 (port 1):
switch_a(config)#interface fe1
switch_a(config-if)#storm-control multicast enable
switch_a(config-if)#
DLF:
1. Command Mode: Interface mode
Logon to Configure Mode (Configure Terminal Mode).
Then logon to Interface mode.
PAGE 141
OSD2700SFP OPERATOR MANUAL
OPTICAL SYSTEMS DESIGN
DOC ID: 10112704