Optical Systems Design OSD2700SFP SERIES Operator's Manual page 199

LLDP PORTS SETTINGS
Transmit:
1. Command Mode: Interface mode
Logon to Configure Mode (Configure Terminal Mode).
Then logon to Interface mode.
fe1 means port 1.
The switch_a(config-if)# prompt will show on the screen.
switch_a(config)#interface fe1
switch_a(config-if)#
2. Usage:
Use this command to send Link Layer Discovery Protocol (LLDP) packets on the interface.
Use the no parameter with this command to disallow sending Link Layer Discovery Protocol (LLDP)
packets on the interface.
3. Command Syntax:
(no) lldp tx-pkt
4. Example:
The following example sends Link Layer Discovery Protocol (LLDP) packets on the interface fe1 (port
1):
switch_a(config)#interface fe1
switch_a(config-if)#lldp tx-pkt
switch_a(config-if)#
Receive:
1. Command Mode: Interface mode
Logon to Configure Mode (Configure Terminal Mode).
Then logon to Interface mode.
fe1 means port 1.
The switch_a(config-if)# prompt will show on the screen.
switch_a(config)#interface fe1
switch_a(config-if)#
2. Usage:
Use this command to receive Link Layer Discovery Protocol (LLDP) packets on the interface.
Use the no parameter with this command to disallow receiving Link Layer Discovery Protocol (LLDP)
packets on the interface.
3. Command Syntax:
(no) lldp rcv-pkt
4. Example:
The following example receives Link Layer Discovery Protocol (LLDP) packets on the interface fe1
(port 1):
switch_a(config)#interface fe1
switch_a(config-if)#lldp rcv-pkt
switch_a(config-if)#
Notify:
1. Command Mode: Interface mode
PAGE 199
OSD2700SFP OPERATOR MANUAL
OPTICAL SYSTEMS DESIGN
DOC ID: 10112704