Optical Systems Design OSD2700SFP SERIES Operator's Manual page 195

4. Example:
The following example specifies the retransmit value 12:
switch_a(config)#radius-server retransmit 12
switch_a(config)#
PORT AUTHENTICATION
Authentication State:
1. Command Mode: Interface mode
Logon to Configure Mode (Configure Terminal Mode).
Then logon to Interface mode.
fe1 means port 1.
The switch_a(config-if)# prompt will show on the screen.
switch_a(config)#interface fe1
switch_a(config-if)#
2. Usage:
Use dot1x reauthetication command to enable reauthentication on a port.
Use no dot1x reauthetication command to disable reauthentication on a port.
3. Command Syntax:
(no) dot1x reauthentication
4. Example:
The following example specifies to enable reauthetication on the interface fe1 (port 1):
switch_a(config)#interface fe1
switch_a(config-if)#dot1x reauthentication
switch_a(config-if)#
Port Control:
1. Command Mode: Interface mode
Logon to Configure Mode (Configure Terminal Mode).
Then logon to Interface mode.
fe1 means port 1.
The switch_a(config-if)# prompt will show on the screen.
switch_a(config)#interface fe1
switch_a(config-if)#
2. Usage:
Use this command to force a port state.
Use no dot1x port-control command to remove a port from the 802.1x management.
3. Command Syntax:
｜
dot1x port-control auto
no dot1x port-control
auto Specify to enable authentication on port.
force-authorized Specify to force a port to always be in an authorized state.
force-unauthorized Specify to force a port to always be in an unauthorized state.
PAGE 195
OSD2700SFP OPERATOR MANUAL
OPTICAL SYSTEMS DESIGN
｜
force-authorized force-unauthorized
DOC ID: 10112704