Optical Systems Design OSD2700SFP SERIES Operator's Manual page 132

ALARM SETTING
Alarm-trigger if:
1. Command Mode: Configure mode
Logon to Configure Mode (Configure Terminal Mode).
The switch_a(config)# prompt will show on the screen.
switch_a(config)#
2. Usage:
Use this command to enable or disable alarm trigger on interface.
3. Command Syntax:
(no) alarm-trigger if INTERFACE
INTERFACE specifies the interface.
4. Example:
The following example enables alarm trigger on interface "fe1" to switch:
switch_a(config)#alarm-trigger if fe1
switch_a(config)#
Alarm-trigger power:
1. Command Mode: Configure mode
Logon to Configure Mode (Configure Terminal Mode).
The switch_a(config)# prompt will show on the screen.
switch_a(config)#
2. Usage:
Use this command to enable or disable alarm trigger of power source.
3. Command Syntax:
(no) alarm-trigger power POWER
POWER specifies the power source.
4. Example:
The following example enables alarm trigger of power "1" to switch:
switch_a(config)#alarm-trigger power 1
switch_a(config)#
PAGE 132
OSD2700SFP OPERATOR MANUAL
OPTICAL SYSTEMS DESIGN
DOC ID: 10112704