Configuration Settings Of The Terminal-Emulation Program - Optical Systems Design OSD2700SFP SERIES Operator's Manual

1.3.2

CONFIGURATION SETTINGS OF THE TERMINAL-EMULATION PROGRAM:

Baud rate: 115,200bps
Data bits: 8
Parity: none
Stop bit: 1
Flow control: none
Press the "Enter" key. The Command Line Interface (CLI) screen should appear as below:
Logon to Exec Mode (View Mode):
At the "switch_a login:" prompt just type in "root" and press <Enter> to logon to Exec Mode (or View
Mode). And the "switch_a>" prompt will show on the screen.
Logon to Privileged Exec Mode (Enable Mode):
•
At the "switch_a>" prompt just type in "enable" and press <Enter> to logon to Privileged
Exec Mode (or Enable Mode). And the "switch_a#" prompt will show on the screen.
• Logon to Configure Mode (Configure Terminal Mode):
At the "switch_a#" prompt just type in "configure terminal" and press <Enter> to logon to
Configure Mode (or Configure Terminal Mode). And the "switch_a(config)#" prompt will
show on the screen.
• Set new IP address and subnet mask for Switch:
At the "switch_a(config)#" prompt just type in "interface vlan1.1" and press <Enter> to logon
to vlan 1 (vlan1.1 means vlan 1). And the "switch_a(config-if)#" prompt will show on the
screen.
Command Syntax: "ip address A.B.C.D/M". "A.B.C.D" specifies IP address. "M" specifies IP subnet
mask. "M"= 8: 255.0.0.0, 16:255.255.0.0, or 24: 255.255.255.0.
For example, At the "switch_a(config-if)#" prompt just type in "ip address 192.168.1.10/24" and press
<Enter> to set new IP address (192.168.1.10) and new IP subnet mask (255.255.255.0) for Switch.
.
PAGE 7
OSD2700SFP OPERATOR MANUAL
OPTICAL SYSTEMS DESIGN
FIGURE 2: CLI LOGIN
FIGURE 3: CLI CONFIG
DOC ID: 10112704