Optical Systems Design OSD2700SFP SERIES Operator's Manual page 87

Add Radius:
1. Add Radius: Click "Add Radius" button. The "Radius Server Setting" window appears.
2. Radius Server IP: Click in the "Radius Server IP" textbox and specify the IP address of the remote
radius server host.
3. Radius Server Port: Click in the "Radius Server Port" textbox and specify the UDP destination port
for authentication requests. The host is not used for authentication if set to 0.
4. Secret Key: Click in the "Secret Key" textbox and specify the authentication and encryption key
for all radius communications between the Switch and radius server. This key must match the
encryption used on the radius daemon. All leading spaces are ignored, but spaces within and at the
end of the key are used. If spaces are used in the key, do not enclose the key in quotaion marks
unless the quotation marks themselves are part of the key.
5. Timeout <1-1000>: Click in the "Timeout" textbox and specify the time interval (in seconds) that
the Switch waits for the radius server to reply before retransmitting. Enter a value in the range 1 to
1000.
6. Retransmit <1-100>: Click in the "Retransmit" textbox and specify the number of times a radius
request is resent to a server if that server is not responding or responding slowly. Enter a value in
the range 1 to 100.
7. Submit: Click "Submit" button when you finished Radius Server Setting.
PAGE 87
OSD2700SFP OPERATOR MANUAL
OPTICAL SYSTEMS DESIGN
DOC ID: 10112704