1. Connect the Console Port on OSD2790 (Mini USB) to PC with USB cable.
2. Using HyperTerminal to set up the following parameters.
•
Baud Rate: 115200
•
Data Bits: 8
•
Parity: None
•
Stop Bits: 1
•
Flow Control: None
3. Check the link by pressing <ENTER>. The line should jump to the next line.
4. Using the Username and password to login the switch
•
Default Username: admin
•
Default Password: (None)
8.2
CLI COMMAND FOR IP CONFIGURATION
•
show ip interface brief: Display the current IP address and subnet mask.
•
configure terminal -> interface vlan 1 -> ip address <IP address> <subnet mask>: Setup the
switch IP address.
•
copy running-config startup- config: Save the current configuration to start-up configuration.
PS: All configuration changes must be saved otherwise all the changes will be lost after
rebooting!
PAGE 12
OSD2790SFP QUICK START GUIDE
OPTICAL SYSTEMS DESIGN
DOC ID: 10117502