Optical Systems Design OSD2700SFP SERIES Operator's Manual page 168

2. Usage:
Use this command to set the Switch timeout count for running chain protocol. Chain recovery time =
(Chain Timeout Count – 1) x 200ms.
Use the no form of the command to restore default value (5).
Default Chain recovery time = (5 – 1) x 200ms = 800ms.
3. Command Syntax:
bridge GROUP chain-timeout <3-255>
no bridge GROUP chain-timeout
Group = <1-1> Bridge Group name for bridging.
<3-255> The Switch timeout count for running chain protocol.
4. Example:
The following example sets the new Switch timeout (10) to bridge GROUP (1):
switch_a(config)#bridge 1 chain-timeout 10
switch_a(config)#
Storm Control:
1. Command Mode: Configure mode
Logon to Configure Mode (Configure Terminal Mode).
The switch_a(config)# prompt will show on the screen.
switch_a(config)#
2. Usage:
Use this command to enable Storm Control (broadcast and multicast) for Chain Protocol setting. Use
the no form of the command to disable Storm Control (broadcast and multicast) for Chain Protocol
setting.
3. Command Syntax:
bridge GROUP chain-storm enable
no bridge GROUP chain-storm
Group = <1-1> Bridge Group name for bridging.
4. Example:
The following example enables chain storm control for bridge GROUP (1):
switch_a(config)#bridge 1 chain-storm enable
switch_a(config)#
Chain Pass-Through Setting
1. Command Mode: Configure mode
Logon to Configure Mode (Configure Terminal Mode).
The switch_a(config)# prompt will show on the screen.
switch_a(config)#
2. Usage:
Use this command to set chain pass-through port 1 and chain pass-through port 2.
3. Command Syntax:
chain pass-through IFNAME IFNAME
no chain pass-through
IFNAME Chain pass-through port number 1.
PAGE 168
OSD2700SFP OPERATOR MANUAL
OPTICAL SYSTEMS DESIGN
DOC ID: 10112704