Trunking - Optical Systems Design OSD2700SFP SERIES Operator's Manual

7.6

TRUNKING

Port Trunking, LACP Trunking
PORT TRUNKING
1. Command Mode: Interface mode
Logon to Configure Mode (Configure Terminal Mode).
Then logon to Interface mode.
fe1 means port 1.
The switch_a(config-if)# prompt will show on the screen.
switch_a(config)#interface fe1
switch_a(config-if)#
2. Usage:
Use static-channel-group command to create a static aggregator, or add a member port to an already-
existing static aggregator.
Use the no static-channel-group command to detach the port from the static aggregator.
3. Command Syntax:
static-channel-group <1-8>
no static-channel-group
<1-8> Channel group number.
Maximum 8 ports in static-channel-group 1 to 6.
Maximum 4 ports in static-channel-group 7 and 8.
4. Example:
The following example adding the interface fe1 (port 1) to static-channel-group 1:
switch_a(config)#interface fe1
switch_a(config-if)#static-channel-group 1
switch_a(config-if)#
LACP TRUNKING
Static Channel Group:
1. Command Mode: Interface mode
Logon to Configure Mode (Configure Terminal Mode).
Then logon to Interface mode.
fe1 means port 1.
The switch_a(config-if)# prompt will show on the screen.
switch_a(config)#interface fe1
switch_a(config-if)#
2. Usage:
Use static-channel-group command to create a static aggregator, or add a member port to an already-
existing static aggregator.
Use the no static-channel-group command to detach the port from the static aggregator.
3. Command Syntax:
static-channel-group <1-8>
no static-channel-group
<1-8> Channel group number.
Maximum 8 ports in static-channel-group 1 to 6.
Maximum 4 ports in static-channel-group 7 and 8.
PAGE 151
OSD2700SFP OPERATOR MANUAL
OPTICAL SYSTEMS DESIGN
DOC ID: 10112704