Optical Systems Design OSD2700SFP SERIES Operator's Manual page 179

DSCP
1. Command Mode: Configure mode
Logon to Configure Mode (Configure Terminal Mode).
The switch_a(config)# prompt will show on the screen.
switch_a(config)#
2. Usage:
Use mls qos map dscp-queue command to map the DSCP values to a queue.
3. Command Syntax:
mls qos map dscp-queue DSCP_VALUE to QUEUE_ID
DSCP_VALUE DSCP values. Up to 8 values (separated by spaces). Range is 0-63.
QUEUE_ID Queue ID. Range is 0-3.
4. Example:
The following example shows mapping DSCP values 0 to 3 to queue 1 on the switch:
switch_a(config)#mls qos map dscp-queue 0 1 2 3 to 1
switch_a(config)#
PAGE 179
OSD2700SFP OPERATOR MANUAL
OPTICAL SYSTEMS DESIGN
DOC ID: 10112704