Optical Systems Design OSD2700SFP SERIES Operator's Manual page 154

4. Example:
The following example sets the LACP short timeout on interface fe1 (port 1):
switch_a(config)#interface fe1
switch_a(config-if)#lacp timeout short
switch_a(config-if)#
LACP System Priority:
1. Command Mode: Configure mode
Logon to Configure Mode (Configure Terminal Mode).
The switch_a(config)# prompt will show on the screen.
switch_a(config)#
2. Usage:
Use lacp system-priority command to set the system priority of a local system. This is used in
determining the system responsible for resolving conflicts in the choice of aggregation groups. Note:
Lower numerical values have higher priorities.
Use no lacp system-priority command to reset the system priority of the local system to the default
value (32768).
3. Command Syntax:
lacp system-priority <1-65535>
no lacp system-priority
<1-65535> LACP system priority. The default system priority is 32768.
4. Example:
The following example sets the LACP system priority 6700:
switch_a(config)#lacp system-priority 6700
switch_a(config)#
PAGE 154
OSD2700SFP OPERATOR MANUAL
OPTICAL SYSTEMS DESIGN
DOC ID: 10112704