Optical Systems Design OSD2700SFP SERIES Operator's Manual page 196

4. Example:
The following example specifies to enable authetication on the interface fe1 (port 1):
switch_a(config)#interface fe1
switch_a(config-if)#dot1x port-control auto
switch_a(config-if)#
Periodic Reauthentication:
Reauthentication Period:
1. Command Mode: Interface mode
Logon to Configure Mode (Configure Terminal Mode).
Then logon to Interface mode.
fe1 means port 1.
The switch_a(config-if)# prompt will show on the screen.
switch_a(config)#interface fe1
switch_a(config-if)#
2. Usage:
Use this command to set the interval between reauthorization attempts.
Use no dot1x timeout re-authperiod command to delete the interval between reauthorization
attempts.
3. Command Syntax:
dot1x timeout re-authperiod SECS
no dot1x timeout re-authperiod
SECS <1-4294967295> Specify the seconds between reauthorization attempts. The default time is
3600 seconds.
4. Example:
The following example specifies to set the interval 25 seconds between reauthorization attempts:
switch_a(config)#interface fe1
switch_a(config-if)#dot1x timeout re-authperiod 25
switch_a(config-if)#
PAGE 196
OSD2700SFP OPERATOR MANUAL
OPTICAL SYSTEMS DESIGN
DOC ID: 10112704