Optical Systems Design OSD2700SFP SERIES Operator's Manual page 153

clear lacp (<1-65535>) counters
<1-65535> Channel-group number.
4. Example:
The following example clears all counters of LACP channel group 1:
switch_a#clear lacp 1 counters
switch_a#
LACP Port Priority:
1. Command Mode: Interface mode
Logon to Configure Mode (Configure Terminal Mode).
Then logon to Interface mode.
fe1 means port 1.
The switch_a(config-if)# prompt will show on the screen.
switch_a(config)#interface fe1
switch_a(config-if)#
2. Usage:
Use lacp port-priority command to set the priority of a channel. Channels are selected for aggregation
based on their priority with the higher priority (numerically lower) channels selected first.
Use the no lacp port-priority command to reset the priority of port to the default value (32768).
3. Command Syntax:
lacp port-priority <1-65535>
no lacp port-priority
<1-65535> Specify the LACP port priority.
4. Example:
The following example sets the LACP port priority 34 of interface fe1 (port 1):
switch_a(config)#interface fe1
switch_a(config-if)#lacp port-priority 34
switch_a(config-if)#
LACP Timeout:
1. Command Mode: Interface mode
Logon to Configure Mode (Configure Terminal Mode).
Then logon to Interface mode.
fe1 means port 1.
The switch_a(config-if)# prompt will show on the screen.
switch_a(config)#interface fe1
switch_a(config-if)#
2. Usage:
Use lacp timeout command to set the short or long timeout on a port. The default is long timeout
3. Command Syntax:
∣
lacp timeout shor l ong
timeout Number of seconds before invalidating a received LACP data unit (DU).
short LACP short timeout. Short timeout value is 3 seconds.
long LACP long timeout. Long timeout value is 90 seconds.
PAGE 153
OSD2700SFP OPERATOR MANUAL
OPTICAL SYSTEMS DESIGN
DOC ID: 10112704