Optical Systems Design OSD2700SFP SERIES Operator's Manual page 186

2. Usage:
Use snmp-server location command to specify and no snmp-server location command to remove
location for SNMP.
3. Command Syntax:
snmp-server location LOCATION
no snmp-server location
LOCATION The location for SNMP.
4. Example:
The following example specifies location (location) for SNMP:
switch_a(config)#snmp-server location location
switch_a(config)#
Contact:
1. Command Mode: Configure mode
Logon to Configure Mode (Configure Terminal Mode).
The switch_a(config)# prompt will show on the screen.
switch_a(config)#
2. Usage:
Use snmp-server contact command to specify and no snmp-server contact command to remove
contact for SNMP.
3. Command Syntax:
snmp-server contact CONTACT
no snmp-server contact
CONTACT The contact for SNMP.
4. Example:
The following example specifies contact (contact) for SNMP:
switch_a(config)#snmp-server contact contact
switch_a(config)#
Trap Community Name:
1. Command Mode: Configure mode
Logon to Configure Mode (Configure Terminal Mode).
The switch_a(config)# prompt will show on the screen.
switch_a(config)#
2. Usage:
Use this command to specify trap community name for SNMP.
Use the no parameter with this command to remove trap community name for SNMP.
3. Command Syntax:
snmp-server trap-community <1-5> NAME
no snmp-server trap-community <1-5>
<1-5> The trap community 1-5.
NAME The trap community name for SNMP.
4. Example:
PAGE 186
OSD2700SFP OPERATOR MANUAL
OPTICAL SYSTEMS DESIGN
DOC ID: 10112704