Command Line Interface (Cli); Terminal Emulation Setup - Optical Systems Design OSD2184P Operator's Manual

OPTICAL SYSTEMS DESIGN
2.4

COMMAND LINE INTERFACE (CLI)

The Command Line Interface (CLI) is a useful tool for checking link status and debugging link
connections. To enable the use of CLI, the OSD2184P must be connected to a PC with a USB port via
a Mini USB to (typically) USB Type A cable. Using a terminal emulation program such as
hyperterminal or SSCOM, a number of command lines specific to the OSD2184P can be implemented.
2.4.1

TERMINAL EMULATION SETUP

Using a terminal emulation program such as hyperterminal, the following parameters should be set up
for correct command line operation. Select the appropriate "COM port" set up for the serial port.
FIGURE 13: CLI PORT SETTINGS
DOC ID: 10119601
PAGE 21
OSD2184P OPERATOR MANUAL