Optical Systems Design OSD2700SFP SERIES Operator's Manual page 125

Restore Default:
1. Command Mode: Privileged Exec mode
Logon to Privileged Exec Mode (Enable Mode).
The switch_a# prompt will show on the screen.
switch_a#
2. Usage:
Use restore default command to restore default setting of the switch.
3. Command Syntax:
restore default
4. Example:
The following example restores default setting of the switch:
switch_a#restore default
switch_a#
Auto Save:
1. Command Mode: Configure mode
Logon to Configure Mode (Configure Terminal Mode).
The switch_a(config)# prompt will show on the screen.
switch_a(config)#
2. Usage:
Use this command to enable auto save configuration function. The configuration will be automatically
saved at every configured interval while this command is enabled. Use the no form of this command to
disable this feature.
3. Command Syntax:
service auto-config enable
no service auto-config enable
4. Example:
The following example enables or disables auto save configuration to switch:
switch_a(config)#service auto-config enable
switch_a(config)#no service auto-config enable
switch_a(config)#
Auto Save Interval (5~65536 sec):
1. Command Mode: Configure mode
Logon to Configure Mode (Configure Terminal Mode).
The switch_a(config)# prompt will show on the screen.
switch_a(config)#
2. Usage:
Use this command to set the interval when the configuration would be automatically saved. The range
of interval value is from 5 to 65535. And the default value is 30 seconds.
3. Command Syntax:
service auto-config interval WORD
WORD specifies the interval value.
PAGE 125
OSD2700SFP OPERATOR MANUAL
OPTICAL SYSTEMS DESIGN
DOC ID: 10112704