1. Connect the Console Port on OSD2888 (Mini USB) to PC with USB cable.
2. Using HyperTerminal or similar, set up the following parameters.
•
Baud Rate: 115200
•
Data Bits: 8
•
Parity: None
•
Stop Bits: 1
•
Flow Control: None
3. Check the link by pressing <ENTER>. The line should jump to the next line.
4. Using the Username and password to login the switch
•
Default Username: admin
Default Password: (None)
•
8.2
CLI COMMAND FOR IP CONFIGURATION
The Command Line Interface (CLI) is a useful tool for checking link status and debugging link
connections. To enable the use of CLI the OSD2888 must be connected to a PC with a USB port using
a Mini-USB cable. Using a terminal emulation program such as Hyperterminal, a number of command
lines specific to the OSD2888 can be implemented
PAGE 11
OPTICAL SYSTEMS DESIGN
OSD2888 QUICK START GUIDE
DOC ID: 10118501