Optical Systems Design OSD2700SFP SERIES Operator's Manual page 204

Managed 24-port 100base sfp and 4- combo port gigabit ethernet switch
Table of Contents

Advertisement

3.
Command Syntax:
set gvrp registration normal IF_NAME
set gvrp registration fixed IF_NAME
set gvrp registration forbidden IF_NAME
normal Specify dynamic GVRP multicast registration and deregistration on the port.
fixed Specify the multicast groups currently registered on the switch are applied to the port, but any
subsequent registrations or deregistrations do not affect the port. Any registered multicast groups on
the port are not deregistered based on the GARP timers.
forbidden Specify that all GVRP multicasts are deregistered, and prevent any further GVRP multicast
registration on the port.
IF_NAME The name of the interface.
4.
Example:
The following example sets GVRP registration to fixed registration mode on the interface fe1 (port 1):
switch_a(config)#set gvrp registration fixed fe1
switch_a(config)#
IGMP SNOOPING
IGMP mode:
Querier:
1.
Command Mode: Configure mode
Logon to Configure Mode (Configure Terminal Mode).
The switch_a(config)# prompt will show on the screen.
switch_a(config)#
2.
Usage:
Use ip igmp snooping querier command to enable IGMP querier operation on a subnet (VLAN) when
no multicast routing protocol is configured in the subnet (VLAN). When enabled, the IGMP Snooping
querier sends out periodic IGMP queries for all interfaces on that VLAN.
Use the no ip igmp snooping querier command to disable IGMP querier configuration.
3.
Command Syntax:
(no) ip igmp snooping querier
4.
Example:
The following example enables IGMP snooping querier:
switch_a(config)# ip igmp snooping querier
switch_a(config)#
IGMP mode:
Passive:
1.
Command Mode: Configure mode
Logon to Configure Mode (Configure Terminal Mode).
The switch_a(config)# prompt will show on the screen.
switch_a(config)#
2.
Usage:
Use ip igmp snooping command to enable IGMP Snooping. This command is given in the Global
Config mode. IGMP Snooping is enabled at the switch level.
Use the no ip igmp snooping command to globally disable IGMP Snooping.
PAGE 204
OSD2700SFP OPERATOR MANUAL
OPTICAL SYSTEMS DESIGN
DOC ID: 10112704

Advertisement

Table of Contents
loading

Table of Contents