Optical Systems Design OSD2700SFP SERIES Operator's Manual page 131

Delete Syslog Server:
1. Command Mode: Configure mode
Logon to Configure Mode (Configure Terminal Mode).
The switch_a(config)# prompt will show on the screen.
switch_a(config)#
2. Usage:
Use this command to delete the logging of messages that are sent to remote syslog servers.
3. Command Syntax:
remote-log del A.B.C.D
A.B.C.D Specifies the IP address of the remote syslog server.
4. Example:
The following example deletes a remote syslog server (IP address: 192.168.1.100) for the switch:
switch_a(config)#remote-log del 192.168.1.100
switch_a(config)#
ARP TABLE
1. Command Mode: Privileged Exec mode
Logon to Privileged Exec Mode (Enable Mode).
The switch_a# prompt will show on the screen.
switch_a(config)#
2. Usage:
Use show arp-table command to view ARP Table.
3. Command Syntax:
show arp-table
4. Example:
The following example shows the ARP Table of switch:
switch_a#show arp-table
ROUTE TABLE
1. Command Mode: Privileged Exec mode
Logon to Privileged Exec Mode (Enable Mode).
The switch_a# prompt will show on the screen.
switch_a(config)#
2. Usage:
Use show route-table command to view Route Table.
3. Command Syntax:
show route-table
4. Example:
The following example shows the Route Table of switch:
switch_a#show route-table
PAGE 131
OSD2700SFP OPERATOR MANUAL
OPTICAL SYSTEMS DESIGN
DOC ID: 10112704