Table of Contents
Advertisement
2.
Usage:
Use this command to set bridge priority for the common instance. Using a lower priority indicates a
greater likelihood of the bridge becoming root.
3.
Command Syntax:
bridge GROUP priority PRIORITY
no bridge GROUP priority
GROUP <1-1> The ID of the bridge group for which the priority is set.
PRIORITY <0-61440> The bridge priority.
4.
Example:
The following example sets the priority PRIORITY (4096) of bridge GROUP (1):
switch_a(config)#bridge 1 priority 4096
switch_a(config)#
Hello Time (sec) (1..9):
1.
Command Mode: Configure mode
Logon to Configure Mode (Configure Terminal Mode).
The switch_a(config)# prompt will show on the screen.
switch_a(config)#
2.
Usage:
Use this command to set the hello-time, the time in seconds after which (if this bridge is the root
bridge) all the bridges in a bridged LAN exchange Bridge Protocol Data Units (BPDUs).
3.
Command Syntax:
bridge GROUP hello-time HELLOTIME
no bridge GROUP hello-time
GROUP <1-1> The ID of the bridge group to which this hello time is assigned.
HELLOTIME <1-9> The hello BPDU interval in seconds.
4.
Example:
The following example sets the hello-time HELLOTIME (9) of bridge GROUP (1):
switch_a(config)#bridge 1 hello-time 9
switch_a(config)#
Max Age (sec) (6..28):
1.
Command Mode: Configure mode
Logon to Configure Mode (Configure Terminal Mode).
The switch_a(config)# prompt will show on the screen.
switch_a(config)#
2.
Usage:
Use this command to set the max-age for a bridge.
Use the no parameter with this command to restore the default value of max-age.
3.
Command Syntax:
bridge GROUP max-age MAXAGE
no bridge GROUP max-age
GROUP <1-1> The ID of the bridge group to which this maximum age time is assigned.
MAXAGE <6-28> The maximum time, in seconds, to listen for the root bridge.
PAGE 157
OSD2700SFP OPERATOR MANUAL
OPTICAL SYSTEMS DESIGN
DOC ID: 10112704
Advertisement
Table of Contents
